| Function |
Automatic Operation |
Automatic battery exchange makes it possible to operate production
lines on a 24-hour continuous, fully automated basis. |
| Manual Operation |
When charger mode is manual mode, It is used to equal charging
and float charging for active charging.
|
| Composition |
Input Transformer |
| Rectifier |
| Protection Equipment |
- Input Circuit : MCCB Attached
- Input Over Current : Fast open Fuse Attached
- Output Over Current : Current Control Circuit
- Output Over Voltage : charging break equipment
|
| Measurely Instrument |
- DC VOLT METER (DIGITAL)
- DC AMP METER (DIGITAL)
|
| Control Unit |
- AUTO/MANUAL MODE SWITCH
- AGV/CHARGER MODE SWITCH
- CHARGER START BUTTON
- CHARGER STOP BUTTON
- ERROR RESET BUTTON
- BUZZER STOP BUTTON
- FLOAT VOLT ADJ. / EQUAL VOLT ADJ. / CURRENT ADJ.
- AUTO CHARGE TIMER
- MAUAL CHARGE TIMER
|
| Condition Indication Unit |
- POWER ON LAMP
- POWER OFF LAMP
- AUTO MODE LAMP
- MANUAL MODE LAMP
- AGV MODE LAMP
- CHARGER MODE LAMP
- CHARGER START LAMP
- CHARGER STOP LAMP
- EQUAL LAMP
- FLOAT LAMP
- CHARGER COMPLETE LAMP
- CHARGER ERROR LAMP
- BATTERY TIME ERROR LAMP
- SPARE LAMP
|
| Alarm Unit |
- CHARGER ERROR :
Fuse, Over voltage / low voltage, Fan error, Temperature error
- BATTERY TIME ERROR:
Battery Error, Charging coupler Error
|
| Charging Coupler |
This charging coupler is received the power unit from charger.
And supply the charging power to the AGV.
- Charging Unit: It has a driving motor and charging pin to the
automatically charging
- PLC: It is a Program Logic Controller for the operatior of
charger
- 8 Bit Sensor: It is sequence for the order of charging start
and complete.
- Control Panel: AUTO/MANUAL MODE SWITCH, START/STOP BUTTON,
ERROR RESET BUTTON, CONDITION DISPLAY LAMP, ERROR LAMP
|
